Does my NYC generator project need a PE?

When a generator job in New York City needs DOB Electrical Plan Review, who can file it, and what the drawings must show.

By Justin M. Strafer, PE, MBA · Updated

The short answer

A generator job needs DOB Electrical Plan Review, filed by a New York licensed and registered PE or RA, when the installation it belongs to totals 1000 kVA or more, or when any part of it runs above 1000 V AC or 1500 V DC. The generator's own size matters too: it changes what the drawings must show.

Generators count as an "installation"

The 2025 NYC Electrical Code §110.2(B) lists generators and generator paralleling equipment alongside service equipment, transformers, UPS systems, energy storage and other sources. No such installation may be built until DOB approves a submission when:

  1. New equipment totals 1000 kVA or more.
  2. A 1000 kVA-or-larger installation changes, up to and including 2nd-level overcurrent protection, unless the change was shown as "future" on the approved plan.
  3. An addition brings the total to 1000 kVA or more.
  4. Added equipment affects clearances around a 1000 kVA-or-larger installation.
  5. Any new or revised installation is above 1000 V AC or 1500 V DC, regardless of kVA.

For a generator, the capacity DOB uses is its maximum kVA output rating (§110.2(C)(2)).

What the drawings must show

1 RCNY §4000-01(b)(1)(iii)(S) sets two cases:

  • Generator under 1000 kVA, inside a 1000 kVA-or-larger submission: a one-line showing how the generator connects to the normal service, including the grounding of the generator frame and neutral bonding where needed (four-pole transfer device).
  • Generator 1000 kVA or larger: a room layout along with the one-line.

Every EPR submission also needs a one-line to the 2nd level of overcurrent protection, a plan view to scale, the available short-circuit current, and a statement that the overcurrent devices are selectively coordinated. A selective coordination report prepared by a PE must be filed before electrical inspection.

Who can file

Only a New York State licensed and registered Professional Engineer or Registered Architect may submit EPR. A master electrician can pull the electrical permit but cannot submit the plan review.

What about smaller generators?

A generator under 1000 kVA on a building whose total stays under 1000 kVA and at or below 1000 V AC does not trigger §110.2(B) on its own. Check the total carefully: DOB sums every service disconnect, new and existing, and an addition that pushes the total to 1000 kVA triggers review. Other DOB filings may still apply.

Filing in 2026

Since September 1, 2026, EPR filings go through DOB's EPR Intake Form. DOB's fee is $650 for an initial filing and $130 for a post-approval amendment. Filings since December 21, 2025 are reviewed under the 2025 NYC Electrical Code.

How our engineer-of-record service works →

General information, not advice for a specific project. Codes and DOB procedures change; check the sources below for the current text.

Have a job going to DOB?

Send the one-line and the equipment list. We'll tell you what the filing needs and quote a fixed fee.

jstrafer@straferengineering.com
Site visits in all five boroughs and across New York State.